|
|
|
|
| DESCRIPTION |
Sonic raised pavement marker adhesive
is a hot poured adhesive consisiting of selected
bitumen and fillers |
| USES |
Sonic is especially formulated for
adhereing to all types of raised pavement markers
to both chipseal and hotmix surfaces. Non-toxic
and unaffected by acids and alkalis. Not resistant
to solvents, oils or greases. Areas contaminated
with these should be avoided. |
|
| PROPERTIES |
Solids |
100% |
| |
Colour |
Black |
| |
Flash Point |
210 Deg C |
| |
Pouring Temperature |
180 Deg C |
| |
Maximum Heating Temp |
200 Deg C |
| |
Softening Point |
105 - 116 Deg C (ASTM D36-91) |
| |
Penetration |
7 - 11 (ATSM D5 - 91) |
|
| SURFACE
PREPARATION |
Surface should be dry
and clean of dust and debris. Any loose chip should
be removed |
| APPLICATION |
Sonic Hoit Melt should be placed in an appropriate
agitated heating vessel and heated evenly until
the pouring temperature is reached. Required quantity
is poured from vessel to adequately support all
four corners or edges of the marker. Marker should
be placed with firm pressure (but not using foot)
as soon as practicable. Under No Circumstances
should maximum heating temperature be exceeded.
If bubbles are seen to form on the surface of
material, this indicates overheating of the product.;
|
| HANDLING
|
Care must be taken to
avoid splashing of hot adhesive. |
| PRECAUTIONS |
Cold water is best treatment
if splashed occur. |
|
| |
|
Material
Safety Data Sheets are are available on request.
Click
here to view.
|
| |
|
All Information
is provided in good faith based on practical experience
and test, however it is subject to change without
notice
|
|
|
|
